Solar Panels Controller Photovoltaic System LED USB Interface Battery Charger

  
Solar Panels Controller Photovoltaic System LED USB Interface Battery Charger. Large-screen LCD display, adjustable charging and discharging parameters. Complete the three-level PWM charging management. Built-in near charging protection, short circuit protection, open circuit protection and reverse connection protection, all of which are self-recovery and will not damage the controller. Dual USB ports make charging more flexible. The WiFi application can be checked and set at any time. Our controllers can be used for international lithium batteries, lithium iron phosphate batteries and lead-acid batteries. 10A 20A size: 11.514.55.5CM.

30A 40A size: 13.5x17x7CM. 50A 60A size: 15.5x19.7x8.6CM.

Suggestions for safe use: 1. This charge controller is automatically recognized by 12/24/48V, before the first installation, please make sure your battery has enough voltage for the controller to recognize the battery type.

The battery cable should be as short as possible to minimize the loss and avoid affecting the judgment of normal voltage. This controller is suitable for ternary lithium battery, lithium phosphate battery and lead-acid battery. The charge regulator is only suitable for regulating solar modules. Never connect other charging power sources to the charging regulator. The controller will generate heat during operation, please pay attention to install the controller on a flat, well-ventilated surface.

How to connect our controller? Connect the battery to the controller.

It is recommended to add an air switch between the controller and the battery to protect the controller and battery. When the controller is connected to the battery, the LCD screen will display the parameters and then set the battery type. If DC output is required to control the load, please set the output control mode first, and then turn on the DC output cut-off switch. Connect the solar panel PV to the controller, provided that the PV input voltage is within the charging working range at the controller end, the controller will enter the charging state.

It is recommended that the controller add an air switch on the battery, solar panel and load for protection. There may be some delays due to flight, holiday, weather, local post, local natural disaster impact. It must also be in the original packaging.

This item is in the category "Home & Garden\Home Improvement\Electrical Supplies\Alternative Energy Supplies\Solar Power Supplies\Solar Panels & Kits". The seller is "rodonite-7" and is located in this country: CN. This item can be shipped worldwide.

1. Color: Red
2. Current: 60A
3. Current Output: 10-60A
4. System Configuration: Other
5. Power Source: Solar
6. Size: Standard
7. Custom Bundle: No
8. Maximum Flow Rate: Other
9. MPN: 989767876
10. Rotor Diameter: Standard
11. Item Length: Standard
12. Wire Gauge: Other
13. Current Type: AC/DC
14. Voltage: 12V 24V 48V
15. Axis Orientation: Vertical
16. Features: Durable
17. Cell Quantity: 10-60A
18. Pliability: Rigid
19. Maximum Input Voltage: 12V 24V 48V
20. Inverter Technology: Battery-Based
21. Current Rating: 10-60A
22. Brand: Unbranded
23. Type: Solar Panel
24. Connector Configuration: Other
25. Model: Other
26. Recommended Environment: Indoor/Outdoor
27. Resistance Properties: Other
28. Charging Mode: PWM (Pulse Width Modulation)
29. Country/Region of Manufacture: China
30. Application: Camping/Hiking, Electronics, Home/Garden
31. Power: Other
32. Product Line: Solar Panels Controller